Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Spring Replacement Cost in Nashville?
Spring replacement in Nashville typically costs $180 – $340 for one torsion spring, and most doors need a matched pair, so plan on roughly $360 – $680 when both are replaced together. The job usually takes about an hour once the right springs are matched to your door’s weight and height. The exact figure depends on spring type, door size, and how much of the hardware has worn alongside the springs, and the written estimate we give you sets the final price.
If your door slammed down or you heard a loud bang from the garage, stop operating it and call (855) 916-8763. We answer 24/7, fast dispatch runs 7am to 7pm Sunday through Friday, and estimates are free.
Key Takeaways
- One torsion spring runs $180 – $340 in the Nashville market; a matched pair is about twice that.
- Extension springs sit at the lower end of the range, torsion springs at the upper end.
- We diagnose before recommending anything, and we repair the existing system first whenever it’s safe and sensible to do so.
- Springs on a door that sits in a hot, unvented garage work harder, and Middle Tennessee summers are unkind to them.
- Estimates are free and the written quote is the price you pay.
Spring Replacement Cost Breakdown (2026)
These are typical estimated ranges for the Nashville market in 2026. Treat them as a planning guide, not a quote: a technician confirms the actual figure on site and puts it in writing before any work starts.
| Item | Typical Estimated Range |
|---|---|
| Single torsion spring replacement | $180 – $340 |
| Matched pair of torsion springs | About twice the single-spring range |
| Spring repair as part of general Starling Garage Door Repair work | $180 – $340 |
| Cable repair alongside a spring job | $130 – $250 |
| Roller replacement alongside a spring job | $110 – $220 |
| Track realignment alongside a spring job | $120 – $240 |
| Opener repair (if the opener was strained by a broken spring) | $120 – $320 |
| Panel replacement (if a panel was damaged when the spring let go) | $250 – $500 |
| Full garage door repair visit, combining items | $150 – $600 |
| New door installation, if the door itself is past saving | $700 – $2200 |
Why the spread? A single spring on a standard one-car door with light use sits near the bottom. A pair of heavy-duty torsion springs on a tall, insulated two-car door sits near the top. Nashville has a lot of both: older homes around East Nashville and Inglewood with modest one-car garages, and newer builds out toward Nolensville and Mt. Juliet with wide, insulated, double-car doors. Heavier doors need stronger springs, and stronger springs cost more.
What Affects Spring Replacement Pricing in Nashville
- Spring type. Torsion springs, mounted on a shaft above the door, cost more than extension springs, which run along the horizontal tracks. Torsion is the better system and the one most modern doors use, so most jobs sit at the upper half of our range.
- Door weight and size. A tall, insulated, double-car door needs heavier wire and more coils than a basic single-car door. That’s a real material cost, not a markup.
- One spring or a pair. If one spring in a matched pair has broken, the other has lived the same life and is likely close behind. Replacing the pair costs about twice the single-spring range but saves you a second visit. We’ll show you the wear on the remaining spring and let you decide.
- What else is worn. Springs rarely fail in isolation. Cables, rollers, and drums take the same daily load. If a cable or a bearing plate is frayed or seized, it needs handling at the same time, and that adds a line item from the table above.
- Garage conditions. An unvented, west-facing garage in a Nashville July gets genuinely hot, and a hot garage is where springs work hardest and fail soonest. A door that lives in full sun and runs twice a day will wear springs faster than one on a shaded, mild garage.
- Access and clearance. A low-clearance garage, a door with a storage rack bolted above the tracks, or a tight ceiling all change how long the job takes. Same springs, more labor.
Is It Cheaper to Repair Springs or Replace the Door?
Repairing the springs is almost always cheaper. A matched pair of springs on a sound door runs roughly $360 – $680; a new door installation runs $700 – $2200, and that’s the door alone. Springs are a wear part, like brake pads. You replace them and keep the door.
Replacement starts to make sense when the door structure itself is failing: cracked and rusted panels, a bent track that can’t be straightened, a delaminated wood door that’s swelling in the humidity, or a door so old that parts are hard to source. Those are the cases we’ll talk through honestly. When the frame and panels are still solid, we repair. Our technicians have up to 15 years of experience and are trained to diagnose the actual failure rather than default to a new door.
Why Do Springs Break in Nashville?
Springs are designed to cycle a set number of times, and they break from metal fatigue, not from abuse. Every open and close is one cycle, and a household that comes and goes several times a day racks up cycles quickly.
Middle Tennessee’s weather speeds up the process at the margins. Springs are oil-tempered steel, and the temperature swing between a humid Nashville summer and a cold January works that steel over time. Where a door is used hard and the garage isn’t climate-controlled, springs tend to give up earlier than the cycle rating suggests. There’s no way to test a spring’s remaining life reliably; if the door feels heavier than usual or the opener has started straining, that’s your cue to have it looked at.
A word on safety here, because this is the part of the trade that genuinely hurts people. Torsion springs are under enormous tension even when the door is closed. Adjusting, winding, or removing one without the right winding bars and training can cause severe injury in a fraction of a second. We don’t walk anyone through doing it themselves, and we’d rather you didn’t try. This is a trained-professional job, full stop. The same goes for the cables, which are under load and can snap with serious force.
How to Save on Spring Replacement in Nashville
You can’t avoid spring replacement if a spring has broken, but you can avoid paying twice for the same problem.
- Do the pair when one breaks. If you have two springs and one has failed, the second is on the same clock. Paying for the pair once costs less than two separate single-spring visits weeks apart.
- Bundle the wear items. If the rollers are flat-spotted or the cables are fraying, handling them during a spring job is cheaper than a second call later. Rolls into one visit, one written estimate.
- Get a written estimate before work starts. Ours is free, and the price is set per job by that written estimate. No surprises halfway through.
- Stop using the door once a spring breaks. Running the opener against a broken spring strains the motor and the gears, and that turns a spring job into a spring-and-opener job. Door springs and opener motors are two different price lines, and the opener repair range is $120 – $320 on top.
- Address the door’s balance, not just the spring. If the door is binding or the tracks are out of alignment, the new springs will wear faster. Getting the whole system right in one visit saves money down the road.
Spring replacement is part of our broader Nashville work, and we handle the whole system – door, springs, cables, tracks, and opener – so one call covers it. Call (855) 916-8763. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
What Brands and Doors Do We Work On?
We’re certified to work on eight major brands: LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. That covers the door manufacturers (Clopay, Amarr, Wayne Dalton, Raynor) and the opener and operator makers (LiftMaster, Chamberlain, Genie, Craftsman), so whichever system is on your Nashville garage, we can tell you exactly what’s wrong with it.
It also means you won’t hear “we don’t service that brand.” We’re a garage door specialist, not a general handyman squeezing a door repair between other jobs. Our three service lines are garage door repair, opener repair, and full installation, and we handle all three. Our technicians have up to 15 years of experience diagnosing springs, cables, tracks, and openers across all eight brands.
How Long Does Spring Replacement Take?
A straightforward pair of torsion springs is usually an hour of work, plus the time to check balance, cables, and rollers. Most jobs are done the same day. Same-day service is available, and estimates are free. If the garage is cluttered under the door or the tracks are blocked, clearing access beforehand keeps the visit quick.
FAQs – Spring Replacement Cost
How much does it cost to replace a garage door spring in Nashville?
One torsion spring runs $180 – $340, and a matched pair is about twice that, so roughly $360 – $680 when both are replaced together. The exact figure depends on spring type, door size, and whether cables or rollers need handling at the same time. Call (855) 916-8763 for an exact quote – estimates are free.
Is it cheaper to replace one spring or both?
One spring is cheaper up front at $180 – $340, but replacing the pair is usually the better value because the second spring has lived the same life and is close behind. Two separate single-spring visits cost more than one pair job. We’ll show you the wear on the remaining spring and give you a written estimate for both options.
Can you come today if my spring is broken?
Yes. Same-day service is available, and we dispatch 7am to 7pm Sunday through Friday. We answer 24/7, and a call outside dispatch hours is booked into the next opening. Call (855) 916-8763 – estimates are free.
Does spring replacement cost more on a two-car door?
Usually yes. A wider, heavier two-car door needs stronger springs with more material, which sits at the upper end of the $180 – $340 single-spring range. An insulated, double-car door is the heaviest common setup. The written estimate after diagnosis sets the final price.
Can I safely replace my own garage door spring?
No. Torsion springs are under extreme tension, and the winding process can cause severe injury without the right tools and training. Cables are under load too and can snap violently. This is a job for a trained technician, and we’d rather you call us at (855) 916-8763 than take the risk.
Starling Garage Door Repair works on eight of the most widely installed garage door and opener brands, covers repair, opener repair, and full installation, and diagnoses the problem before recommending anything. We check the whole door – springs, cables, rollers, tracks, and the opener – because a spring job that ignores the rest just moves the next breakdown a few months down the road. Every price is confirmed in writing, per job, before work begins. Call (855) 916-8763 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday, and we’re closed on Saturday.
Pricing reflects the Nashville market as of 2026. Starling Garage Door Repair offers free estimates – call (855) 916-8763.
Written by the team at Starling Garage Door Repair.
What Our Customers Say
"Replaced the bottom panel after I backed into it. Color match is close enough that you have to know to look for it."
- Destiny Bryant"Good repair, reasonable money. The door still has a slight shudder about a foot from the top that he said is the track being slightly out of true on an old frame and would cost real money to fix properly. Fair enough, but I'd hoped it would be perfect."
- Bryce Anderson"Door installed in about four hours, old one hauled away, and he stayed to program both cars and the wall panel before he left."
- Brooke Lawson